Transformation of LED lamps USA -> EU

We offer a professional conversion of the set of lamps for the Ford mustang vehicle - Sequential / dynamic turn signals + fog light, adapting to European standards.

This type of conversion is the best on the market. Our modifications can be seen all over Europe: Germany, UK, Italy, Finland etc. The modification is sequential, as the stop light up the rings, the fog is also in the lamp, when it is turned on, the stop lights only externally to maintain a distance of 10 cm from the stop / fog light. It is also possible to make a sequential stop.

When ordering from us, you receive the support of a company dealing with professional tuning of American cars, and the quality of our services is provided by hundreds of satisfied customers from almost all over the world.

The entire modification to the diodes is done with all calculations of loads and cable cross-sections, the entire completed installation is secured with fuses, there is no possibility of burning / damaging SJB or BCM drivers. diode modification is done without any low resistance resistors to act as a heater.

The effect of the projects can be seen here: https://www.youtube.com/watch?v=w5x1i65F29U

Ford Mustang LED lamps 2013-2014

After making the purchase, please send the well-protected lamps along with the contact details to the company's address provided in a separate tab. In addition, a cable (about 20 cm) protruding from the lamp to the trunk should be attached. We cannot provide the service without cables.

The ability to solder wires and a basic knowledge of electronics will be required for the connection. The time that will be needed, depending on the skills, is about 2-5 hours. It is also possible to install the set in our workshop in Opole. After connection, there is no need to code the lamps / computer

After the modification of full LED lamps, we undertake to repair them for life in the event of any defects regarding the modification itself. In the event of a resale of the vehicle, the new buyer is subject to these conditions for a period of 2 years.

Ready lamps are sent back together with the necessary elements for their connection at our expense. The schematics are sent via e-mail, so please include your address in the information.

In the return package you will find: cables, a separate fog switch.

In the return package you will not find: basic tools, tin, rosin, quick couplings, heat shrinkable tubing, silicone or tape.

Fog switch

We use a separate fog light switch for modifications. This is the easiest way and does not require much intervention. It can be mounted anywhere: on the board under the switch or in the driver's legs without drilling a hole.

The price is for the modification of original lamps. In the case of already converted (opened) lamps or replacements, the price may change depending on the need to use additional materials and the time spent on repair.

In such cases, the warranty conditions may also change. We also inform you that in extreme cases we may refuse to undertake the repair.

The lead time is about 1-3 days after receiving the package.

Satisfaction with the modification of lamps by HD-Customs is crushing into the seat;)